34mm Cantilever Scope Mount 6061-T6 Aluminum Screw Clamp Matte Black

This is the big-bore version of a no-nonsense cantilever mount , built for 34mm optics and designed to stay locked in place. No quick-detach levers, no gimmicks. This mount uses a screw-clamp system that secures directly to a Picatinny rail for a solid, repeatable hold once torqued.

The one-piece body is precision-machined from 6061-T6 aluminum, giving you strength where it matters without unnecessary bulk. The forward cantilever design provides proper eye relief for AR-style rifles and modern platforms running larger tube optics.

The scope rings clamp evenly using T15 Torx or #3 Allen screws, delivering consistent pressure and a secure grip on larger 34mm scope tubes. Clean matte black finish, reinforced geometry, and a low-profile design keep this mount rugged without being overbuilt.

This mount is 34mm specific and does not use polymer inserts , it’s designed to clamp directly to the scope tube as intended.

⸻

Mount Specifications

• Ring diameter: 34mm

• Height over rail (centerline): 1.52 in

• Forward cantilever offset: approx. 4.8 in

• Overall length: 5.3 in

• Ring width: 0.75 in

• Weight: 5.5 oz

Measurements are approximate and may vary slightly due to manufacturing tolerances.

⸻

Recommended Torque (Guidance Only)

• Ring screws: 15–20 in-lbs

• Rail clamp screws: 35–45 in-lbs

Torque values are provided as general guidance only. Always follow the scope manufacturer’s recommendations and use a calibrated torque wrench. Do not over-torque.

⸻

Included

• Cantilever scope mount

• Ring caps

• Mounting hardware

• Allen/hex key

This is the mount you install once and stop worrying about. No levers to snag, no shortcuts , just a solid platform for serious glass.

Remember, stay sharp, stay ready, shoot straight!